Robonect.de

Hi, Is it possible to start a job via MQTT and give also the 'Remote start' parameter? I want to start automaticly via Openhab at some time the mower at that startpoint. It would also be nice to have access to the 'Joystick' commands via MQTT ;) Then I could automaticly give a direction when he reac...

These are the screenshots from the first example

Here is another example.
As you can see, he's sleeping, while he should be mowing

Hi,

Here are some screenshots.
In the first you can see that he is still sleeping, while he must be mowing.

Here are the timer-settings

Hi, I have a Husqvarna 305 2021 and use Robonect more than a yer without a problem. I upgraded the firmware to 1.3b. a couple days later a notice that my robot did not start automaticly with the timer. Is still shows AUTO, and the time, but won't start. I have to login into robonect, and press AUTO....

I think I know the problem. I power the relay with a solar powerbank. Sometimes I can't reach the relay also not via IP via the network. After measuring the voltage on the relay, I sow that it was not 5V , even when the powerbank was fully charged. After disconnecting, an reconnection again, it was ...

Hi,

In my profile, I can select my mower (Husqvarna 305), but is seems this is the older model, since I can't select year 2021 for firmware.

Is the a possibility to add model 2021 to the list?

Thank you

Hi,

I have to say that this is not happen always. But 3 a 4 times per week.

For the rest, I like Robonect very much

Also the pushover and other options are very nice.

Hi, Today I installed the Multifunktionsrelais. Everything is working fine, the only problem is that I always get the error mail: Passage module malfunction! The Passage could not be opened / closed! Check the connection and settings! But the relay open and close as expected. The notification 'In ca...

Hi, I know it's a very small bug, but I just want it to let you know that the production-date is showing wrong on a Husqvarna 305 model 2021. It shows 01.01.1970 00:00 http://www.vms.be/tmp/Robonect_Production.jpg Since the image is not shown in the forum, is here the link http://www.vms.be/tmp/Robo...