Frequent collision area detection
Purpose:
Get an understanding of where i need to adjust my cable Installation (Boundary Wires)
Problem:
The cable Installation is never perfect ... too close in some areas causing collisions. If we just change the setting of how far the mower goes beyond the boundary wire, we get unmowed areas. Giving the user a hint of where we have frequent collisions would help.
Method:
- Send/note position when the mower collides with something/detects a collision
- Collect this information in a table with the three (or n) most common collision positions
- User can adjust cable until there is no or few collisions
/Micael
Aufgrund derzeit hohem Spamaufkommens werden neue Nutzer sehr restriktiv behandelt. Nach kurzer "Bewährungszeit" hat man als normaler Nutzer weitreichende Rechte und benötigt auch kein Captcha mehr.
.
Nutzer, die sich danach dennoch als Spammer oder Trolle erweisen, können jederzeit wieder auf diesen Status zurückgesetzt oder gebannt werden.
Dasselbe gilt für Versuche, politische Überzeugungen kund zu tun, egal aus welcher Richtung diese kommen.
.
. Achtung! Derzeit ist Robonect (noch) nicht mit dem Automower 305 ab Baujahr 2020 zusammen mit der neuen Mäher-FW MSW 41.4.0 kompatibel!
Aber: Im DailyBuild ist ein Patch enthalten, der getestet werden kann! (Stand 15.02.2024)
.
.Du hast Deinen Gardena-Mäher auf die Gardena-Firmware von 2023 aktualisiert?
. Testmöglichkeit für das Daily Build.
Das FW-Update am Mäher wird dennoch nicht empfohlen, da das Daily Build nach aktuellen Berichten von Beta-Testern noch keine vollständige Kompatibilität gewährleisten kann! (Stand: 15.02.2024)
Wir empfehlen, das Gardena-Update noch nicht durchzuführen!
.
.
Frequent collision area detection
-
- sehr erfahrener Forum-Nutzer
- Beiträge: 698
- Registriert: Di 14. Feb 2017, 17:07
- Mäher: Husqvarna Automower 330X
- Firmware des Mähers (MSW): MSW 7.xx.xx
- Herstellungsjahr: 2014
- Robonect-Modul: Robonect Hx (Rev.1)
- Robonect Firmware: V1.3b
- hat sich bedankt: 8 Male
- wurde gedankt: 81 Male
Re: Frequent collision area detection
Hello Cognac,
this is a good idea, but unfortunately the mower does not report a collision to Robonect. Therefore, despite GPS, Robonect cannot determine where the boundary wire is too close to the edge.
Greeting
Lampi
this is a good idea, but unfortunately the mower does not report a collision to Robonect. Therefore, despite GPS, Robonect cannot determine where the boundary wire is too close to the edge.
Greeting
Lampi
Fragen? Fragen!
-
- Forum-Anfänger
- Beiträge: 2
- Registriert: Mi 3. Jun 2020, 16:25
- Mäher: Husqvarna Automower 430X
- Robonect Firmware: -
Re: Frequent collision area detection
Thanks Lampi!
I really appreciate the forum and your good work!
/M
I really appreciate the forum and your good work!
/M