Hi
It looks like the Operational Hours->Mowing times not being updated when running in "Mowing time adjustment:->Extend Mowing Time". On the other hand Seek times are being updated.
Is anyone seen this or confirmed earlier? I can send more data/debug if needed/instructed.
Here are the details of my current firmware
Bootloader
Version: V1.0
Compiled: 14.12.2017 23:10
Comment: Release V1.0
WLAN
AT-Version: V1.6.0
SDK-Version: V2.2.0
Compiled: Unknown
ZeroConf
Version: V1.4
Compiled: 09.07.2019 22:49
Comment: ZeroConf V1.4
Application
Version: V1.1
Compiled: 25.0
9.2019 08:54
Comment: V1.1b
Mowing times not being updated
- shadowkiller
- Forum-Veteran
- Beiträge: 4475
- Registriert: Do 11. Jan 2018, 08:42
- Wohnort: Würzburg
- Mäher: Husqvarna Automower 315
- Firmware des Mähers (MSW): MSW 10.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: 1.3 (WLAN 1.7.4)
- hat sich bedankt: 160 Male
- wurde gedankt: 135 Male
Mowing times not being updated
If using extend mowing time, mowing times are no longer logged. This is because Robonect uses the manual mowing mode for this, where no logging of mowing times is used by the mower. Robonect only shows, what the mower is logging.
So this is a normal behavior, not a bug.
So this is a normal behavior, not a bug.
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)