V1.3: MQTT config for Passage does not save

[maglub]

Hi,

* Installation - Passage - MQTT configuration does not save.

When I select "MQTT" in the "Passage" configuration, and add a configuration and press save, the data I added to the form is not saved. The fields are empty.

When I use the same config in the "Garage door" menu, it accepts the configuration and I can control the device (Relay ordered from robonect.de) per MQTT.

Lawnmower: Automower 430X

Bootloader
Version: V1.1
Compiled: 03.09.2020 11:14
Comment: Release V1.1
WLAN
AT-Version: V1.7.4
SDK-Version: V3.0.5
Compiled: 10.07.2020
ZeroConf
Version: V1.6
Compiled: 03.09.2020 12:42
Comment: ZeroConf V1.6
Application
Version: V1.3
Compiled: 28.06.2021 20:30
Comment: V1.3


On my other lawnmower (an Automower 450X with the firmware V1.1b) the MQTT config for the Passage works.

[Admin]

Confirmed. Fixed in ipcoming version.

(The values are saved, but not visible there. Robonect are using them anyway)