My Automower 420 refuses to mow complaining about errorcode 19 "rear bump sensor defect"
Which sensor is that? Aren't bump sensors joysticks on each side left and right? If so then ehoch one of two is has problems?
Is it possible to fix it by cleaning contacts for example or not?
Rear bump sensor defect [SOLVED]
-
- sehr erfahrener Forum-Nutzer
- Beiträge: 706
- Registriert: Di 14. Feb 2017, 17:07
- Mäher: Husqvarna Automower 330X
- Firmware des Mähers (MSW): MSW 7.xx.xx
- Herstellungsjahr: 2014
- Robonect-Modul: Robonect Hx (Rev.1)
- Robonect Firmware: V1.3b
- hat sich bedankt: 8 Male
- wurde gedankt: 82 Male
Re: Rear bump sensor defect
Hello bortek,
your mower only has one bump sensor at the back and it is located on the right Joystick. It's a magnet that switches a reed contact. The left Joystick is not equipped with a bump sensor.
Cleaning the contacts might help.
However, a possible simple reason for the error could also be that the magnet or the circuit board with the reed contact is no longer properly seated in the holder.
Greeting
Lampi
your mower only has one bump sensor at the back and it is located on the right Joystick. It's a magnet that switches a reed contact. The left Joystick is not equipped with a bump sensor.
Cleaning the contacts might help.
However, a possible simple reason for the error could also be that the magnet or the circuit board with the reed contact is no longer properly seated in the holder.
Greeting
Lampi
Fragen? Fragen!