I just received this error message, "Hard-fault occurred". How do I find out what the cause is? Or should I just ignore this and try the new 1.0 beta 4 instead?
Husqvarna Automower 330X
MSW Software: 430X
MSW Version: 7.04.00
MSW Date: 2016-03-24 09:50:39
SUB-Version: 6.00.00
Watchdog 0x08008A54
- shadowkiller
- Forum-Veteran
- Beiträge: 4475
- Registriert: Do 11. Jan 2018, 08:42
- Wohnort: Würzburg
- Mäher: Husqvarna Automower 315
- Firmware des Mähers (MSW): MSW 10.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: 1.3 (WLAN 1.7.4)
- hat sich bedankt: 160 Male
- wurde gedankt: 135 Male
Re: Watchdog 0x08008A54
Hey,
If You can’t replicate the error, the update will make no sense. If the error occur often, it may be good to see, if it gets better under Beta 4.
It also may be a good idea to use Beta 4, because there you can use the download of the log to see, what this error is coming from.
Please first of all write a PM @admin to see, what he would prefer. Also he’s the only one person, who can interpret the log.
(Sorry for my bad English)
shadowkiller
If You can’t replicate the error, the update will make no sense. If the error occur often, it may be good to see, if it gets better under Beta 4.
It also may be a good idea to use Beta 4, because there you can use the download of the log to see, what this error is coming from.
Please first of all write a PM @admin to see, what he would prefer. Also he’s the only one person, who can interpret the log.
(Sorry for my bad English)
shadowkiller
Anleitung zur Erstinstallation
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)
--
Robonect® Dokumentation (= Gebrauchsanweisung = Bedienungsanleitung) und Support
--
Forum cooler nutzen: Hervorhebungen machen und Screenshots posten
--
Es wurde schon alles gefragt, nur noch nicht von allen. (frei nach Karl Valentin)
-
- Forum-Anfänger
- Beiträge: 9
- Registriert: So 23. Jul 2017, 23:11
- Mäher: Husqvarna Automower 330X
- Firmware des Mähers (MSW): MSW 7.xx.xx
- Herstellungsjahr: 2013
- Robonect-Modul: Robonect Hx (Rev.4)
- Robonect Firmware: 1.0beta6a
Re: Watchdog 0x08008A54
Well it just happened once but I got curious what the error might mean
I might stick with 0.9e for a while longer but the upgrade itch is getting stronger. Seems to be a lot of nice features in the new release!
(There is nothing wrong with your English! )
I might stick with 0.9e for a while longer but the upgrade itch is getting stronger. Seems to be a lot of nice features in the new release!
(There is nothing wrong with your English! )