When adding MQTT to Home Assistant, the following message appears when Home Assistant is trying to autoconfigure:
Tue May 15 2018 12:17:05 GMT+0200 (CEST)
Can't decode payload b'33 \xb0C' on homeassistant/health/climate/temperature with encoding utf-8
Is this an error in Robonect FW or in Home Assistant?
UTF8 error connecting MQTT to Home Assistant
- Andreas
- Forum-Nutzer
- Beiträge: 31
- Registriert: Mo 10. Apr 2017, 20:29
- Wohnort: Harrislee
- Mäher: Gardena R70Li
- Firmware des Mähers (MSW): MSW 5.xx.xx
- Herstellungsjahr: 2015
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: V1.0 Beta 7a (Bootloader v0.4)
- Kontaktdaten:
Re: UTF8 error connecting MQTT to Home Assistant
Just a guess, but consider to deactivate the units and only send raw numbers, it looks like there is the "°C" information added right beyond the value, you are interested in.
Vielen Dank und viele Grüße,
Dipl.-Inform. (FH) Andreas Link
Robonect Integration in OpenHAB2 via MQTT
Dipl.-Inform. (FH) Andreas Link
Robonect Integration in OpenHAB2 via MQTT
-
- Administrator
- Beiträge: 2907
- Registriert: Di 19. Jan 2016, 18:34
- Wohnort: Kiel
- Mäher: Gardena SILENO City 500
- Firmware des Mähers (MSW): MSW 11.xx.xx
- Herstellungsjahr: 2017 (Modell 2018)
- Robonect-Modul: Robonect Hx (Rev.5)
- Robonect Firmware: stets die Allerneuste :-)
- hat sich bedankt: 1 Mal
- wurde gedankt: 60 Male
- Kontaktdaten:
Re: UTF8 error connecting MQTT to Home Assistant
I think Andreas is right.
@Andreas: Should i remove the "°" or should I encode it UTF8?
@Andreas: Should i remove the "°" or should I encode it UTF8?
Werbefläche zu vermieten.
- Andreas
- Forum-Nutzer
- Beiträge: 31
- Registriert: Mo 10. Apr 2017, 20:29
- Wohnort: Harrislee
- Mäher: Gardena R70Li
- Firmware des Mähers (MSW): MSW 5.xx.xx
- Herstellungsjahr: 2015
- Robonect-Modul: Robonect Hx (Rev.3)
- Robonect Firmware: V1.0 Beta 7a (Bootloader v0.4)
- Kontaktdaten:
Re: UTF8 error connecting MQTT to Home Assistant
I think a conversation to UTF8 is in general a good idea for data transported via MQTT, but regarding the initial problem of @magnushq it should be sufficient so simply deactivate the hook as marked in the following picture (sorry I cannot decrease the presented size):
This will - as a result - only send the plain numbers to the MQTT broker aka Home Assistant and I assume, then it will be happy. --> @magnushq to verify
Vielen Dank und viele Grüße,
Dipl.-Inform. (FH) Andreas Link
Robonect Integration in OpenHAB2 via MQTT
Dipl.-Inform. (FH) Andreas Link
Robonect Integration in OpenHAB2 via MQTT